Page 125 - ZSi-Foster-Engineering-Catalog
P. 125

 W5760
Flange To Flange Clamp 53#/C (24 Kg)
Cut W200 1-1⁄2" less than inside flange dimension.
Strut (not included)
Adjusting Screws Included
Allowable Load Lbs. (kN) 800 (3.56 kN)
W5761 Series
U-Bolt Beam Clamp with J-Bolt 9" - 12"
229mm - 305mm
5"
127mm
1⁄4"
6mm
All Rods are shown with jamb nuts or “Locking” provision as recommended
Part No. Wt. Lbs/C
W575556CLIPS
3⁄8" 10mm Dia. J-Bolt
W5760 53 (24 Kg)
Allowable load capacity for both horizontal and vertical loads
Use with: W150, W201
• 1" Max. Flange Thickness
• For use with 1-5⁄8" to 3-1⁄4" high channel (W150)
• Recommended Torques: U-Bolt Nuts 150 in-lbs J-Bolt Nut 60 in-lbs
• Includes;
1ea. - Beam Clamp (W5761EG) 3ea. - 3⁄8"-16 Hex Nuts (W7462EG)
ZSi-Foster Engineering Catalog
– 125 –
Beam Clamps Standard Finish: Electro Galvanized
Technical Gamma Rooftop Concrete Beta Clamps Loop & Ring Spring Electrical Pipe & Conduit General Channel Nuts Channel Introduction Data Pads Supports Inserts & Z-Clamps Clamps Steel Fittings Supports Fittings & Hardware
WARNING: These products can expose you to chemicals including lead, which is known to the State of California to cause cancer, and which is known to cause birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
Part No.
W5761 W5761-9 W5761-12
For Flange Width
4" thru 5-7⁄8"
(102mm thru 149mm)
6" thru 9"
(152mm thru 229mm)
9" thru 12"
(229mm thru 305mm)
Wt. Lbs/C
129 (58.5 kg) 167 (75.7 kg) 176 (79.8 kg)
W201 3"
76mm
W5761PBH Only























































   123   124   125   126   127